GeekVape Wenax S Pods

Description

Two disposable cartridges for your Wenax S3 podmod

The Wenax S cartridge for Geekvape’s Wenax S3 podmod is fitted with a 2ml tank and is fitted with a sealed coil (0.8 or 1.2ohm).

Made from PCTG, this cartridge is sturdy and protects your e-liquid from everyday life’s issues. Fitted with a magnetic connector, they can easily be clipped and unclipped from the Wenax S3’s base.

The Wenax S cartridge for Geekvape’s Wenax S3 podmod is fitted with a 2ml tank and is fitted with a sealed coil (0.8 or 1.2ohm).

Made from PCTG, this cartridge is sturdy and protects your e-liquid from everyday life’s issues. Fitted with a magnetic connector, they can easily be clipped and unclipped from the Wenax S3’s base.

Two coil values to choose from

To satisfy all vapers, Geekvape offers you two different coil values:

• A 0.8ohm sealed coil, ideal for a slightly airy draw with a restricted direct inhale (RDL), to be used between 14 and 18W
• A 1.2ohm sealed coil, delivering a tight draw with an indirect inhale (MTL), to be used between 9 and 13W

Whenever your coil starts wearing out, you might feel a loss of flavor or a burnt taste, generally after 2-3 weeks. This means that you need to replace your whole cartridge: unclip it from the mod’s base and replace it with a new one, then wait for about 10 minutes after filling the tank to make sure the new coil is primed.

A simple side-fill system

Even though the Wenax S disposable cartridge is fitted with a non-replaceable coil, you can still refill its 2ml tank with e-liquid.

Take a bottle of your favorite e-liquid and proceed as follows:

1. Remove the cartridge from its magnetic base
2. Pull the silicone tab on the side
3. Insert the tip of your e-liquid bottle into the dedicated hole
4. Fill the tank three-quarters full
5. Close the silicone tab
6. Put the cartridge back onto the mod’s base
7. Wait for about 10 minutes to make sure the coil is primed (if you’re using a new cartridge)