VooPoo ITO Coils

Voopoo ITO Coils are compatible with the VOOPOO Doric 20 Kit and ITO Pod Cartridge etc. ITO Series Coils utilize the new patented technology of VOOPOO, which can increase the atomization area inside the coils, and improve the heating speed. You can enjoy a powerful flavor with ITO Coils.

There are also VOOPOO’s PnP Coils and TPP Coils available.

Parameters:

Brand：VOOPOO
Product Name：ITO Mesh Coil
Coil Type：

• ITO-M0 0.5 ohm, 18-25W ≤20mg         RDL
• ITO-M1 0.7 ohm, 14-18W 20-30mg      MTL
• ITO-M2 1.0 ohm, 10-14W 20-50mg      MTL
• ITO-M3 1.2 ohm, 8-12W  ≤50mg Tight MTL

Fit for：

• Doric 20 Kit
• ITO Pod
• Drag Q
• Argus Pod
• Argus Pod SE
• Argus Pod Nano

5 pieces in each pack

Note that with the 1 and 1.2 ohm coil, you can use any type of e-liquid, with high nicotine content, nicotine salt or CBD. However, prefer high PG ratios, i.e. e-liquids composed of 50% or more of propylene glycol.

How correctly use your ITO Coil ?

As with any component of your electronic cigarette, a properly adjusted and used resistor will last you longer. So remember to prime it before installing it in your tank, to be patient after filling your tank to be sure it is well soaked, or not to exceed the power range recommended by the manufacturer.

A coil is usually changed every 2 to 3 weeks. On the ITO-X cartridge of your Drag Q pod, you will proceed as follows:

1. Remove the cartridge from the podmod’s magnetic base
2. Turn it over
3. Remove the old coil
4. Unpack a new coil
5. Soak its cotton with a few drops of e-liquid
6. Place it in the centre of the tank, in the dedicated space
7. Proceed to the filling if necessary

The ITO Coils for Drag Q pod and ITO-X cartridge are made by Voopoo. They are only sold in set of 5.